板材模頭系列

詳情

JW-B-C1

標準衣架式流道設計，. 上模唇采用推拉式或推出式微調，下模唇可換，調節范圍最大達5mm,適用生產PC、PMMA、GPPS、PET.等單層或多層高透明片材或板材。,

Standard coat-hanger design, the upper die lip adjusting adopts the push- pull type or push- out fine- tuning type,thelower die lip can exchange, the maximum adjusting range up to 5 mm, it is suitable for the production of PC, PMMA,GPPS, PET, single-layer or multi-layer high transparent sheet or plate

JW-B- A2

重型模頭采用標準衣架式流道設計，上模唇可調、下模唇可換及45度調節阻流棒調節裝置,能夠滿足不同厚度制品的需求。適用生產寬度在2000mm以下,厚度3-30mm的ABS、PE、PP厚板。

With special coat-hanger channel design, adjustable upper die lip, changeable lower die lip and 45° blocking bar, thedie adapt to ABS, PE, PP thick plate with the width below 2000mm and thickness between 3- -30mm.

詢價

• 上一個：片材模頭系列

• 下一個：多層共擠分配器